How We Repair Your American Standard Furnace
Furnaces, boilers, heat pumps, radiant systems and space heaters produce heat with burners, elements or a heat pump circuit, protected by safety controls.
American Standard Furnace models often use model-specific control boards, sensors and diagnostic modes. We look up your exact model number so the right part goes in the first time.
Safety first: Install carbon monoxide detectors near sleeping areas. If one sounds, leave the home and call 911.
Common Furnace Problems We Fix
Heat pump blowing cool air in heat mode
A failed reversing valve, defrost control or low refrigerant.
Boiler leaking or losing pressure
A failed relief valve, expansion tank or leaking fitting.
Strange noises
Worn blower motor bearings, a cracked heat exchanger or air in boiler lines.
No heat
A dirty flame sensor, a failed igniter, a tripped limit switch, a thermostat problem or a pilot that will not stay lit.
Short cycling
An overheating furnace from a dirty filter, a faulty limit switch or an oversized system.
Quick Checks Before You Call
These are safe for most owners and sometimes solve the problem without a visit:
- Replace the furnace filter
- Check the thermostat setting and batteries
- Make sure the furnace power switch and gas valve are on
Still not working? Call (844) 442-1500 or try our troubleshooting wizard.
Our 5-Step Repair Process
- Call or book onlineTell us what your American Standard furnace is doing and when it started. We schedule the first available visit.
- DiagnosisThe technician checks power, controls and the parts most likely to fail, using the model's service data and test modes.
- Upfront quoteYou get the cause, the repair and the price before any work starts. If repair does not make sense, we tell you.
- RepairWe install original or equivalent parts matched to your model and clean up when we are done.
- Test and warrantyWe run the appliance through a full cycle to confirm the fix. The repair is covered by our 90-day parts and labor warranty.
Parts We Replace Most Often
- Igniters and flame sensors
- Limit switches
- Blower motors and capacitors
- Gas valves
- Circulator pumps
- Reversing valves and defrost boards
Cost and Lifespan
Most furnace repairs cost $150–$650 including parts and labor, and these appliances typically last 15–25 years. These are national estimates: your exact price comes after the diagnosis. Use the repair vs replace calculator to compare.
Keep It Running Longer
- Have gas heating checked each fall
- Keep vents and returns open
- Change filters regularly
Furnace Repair in Ohio
We repair furnaces in 512 cities and towns across Ohio. Hot summers, cold winters and hard water across much of Ohio wear on homes across the state washers, water heaters and refrigerators.
Frequently Asked Questions
How much does American Standard Furnace Repair cost in Ohio?
Most furnace repairs fall between $150–$650 including parts and labor. The final price depends on the part that failed and your model. You get an exact quote after the diagnosis and before any work starts.
Can you repair my furnace today?
Same-day visits depend on technician availability in Ohio. Call (844) 442-1500 early in the day for the best chance of a same-day or next-day appointment.
Is the repair guaranteed?
Yes. Parts and labor are covered by our 90-day warranty. If the same problem comes back within that time, we return and fix it.
Do you work on all American Standard models?
We repair current and older American Standard models. Some discontinued parts can be hard to find; if that is the case for your model, we tell you before you pay for a repair.
Should I repair or replace my furnace?
A furnace typically lasts about 15 to 25 years. If yours is well inside that range and the repair costs less than half the price of a new one, repairing usually makes sense. Near the end of its life, or when the repair costs more than half of a replacement, replacing is often the better value. We give you an honest opinion either way.